1WARNINGA radio-controlled model is not a toy and is not intended for persons under 16 years old. Keepthis kit out of the reach of younger children,
101. Draw a center line on the bottom of the fuse-lage just in front of the rudder hinge line. Mount the base of the ventral fin along thecenter li
113. Bend the pushrod tube around till it is restingon top of the float with the water rudder. Tie the middle of the tube to the rear strut.TIE TO
12Actual Photos of The CGP Cub ARF.The Superfloats 36 ARF installed on theCarlGoldbergCub!
2ITEMS NEEDED FOR INSTALLATION ON MOD-ELS OTHER THAN CGP CUB 2 24” LENGTHS OF 5/32” WIRE (FOR NEWSTRUTS) 2 CG 5/32 LANDING GEAR CLAMPSNOTE: The Supe
3INTRODUCTIONUSING THIS INSTRUCTION MANUALBefore you begin assembling your Superfloats ARF, takesome time to read through this entire instruction book
4 (1) Rudder (1) 1/2” Rudder Pivot (1) 5/32 x 2-1/16” Rudder Shaft (5) Nylon Bearings (5) Brass Collars (1) Steering Arm (16) 4-40 x 1/2 “ Sock
WATER PROOFING. We have found other than the floatsare absolutely water proof, the plane needonly be water resistant. For example, youshould use a hoo
6FLOAT FLYING BALANCE MOVE BALANCE POINT 1/4” TO 3/8” FORWARDLAND FLYING BALANCE POINTFOR FLAT BOTTOM WINGBOTTOM OF THE WING SHOULD BE PARALLEL TO TOP
711-1/4”The following instructions are for installation of the floats onthe CGP Cub. 1. Remove present landing gear struts and savethem for “wheel”
81. Install one nylon bearing and mounting pad atfront float hole locations. Using four #4 x 1/2” socket head screws andwashers, mount pads and bea
93. Prepare to fasten the nylon rudder bearing tothe rear of the float using four #4 x 3/8”screws.4. Look at your rudder control horn linkage onthe
Commentaires sur ces manuels